PYLE PLPN-W10 10+ Pentagon Shaped Subwoofer Driver
Posted on | December 16, 2009 | 1 Comment
10″ Pentagon Shaped Subwoofer Driver.PRODUCT FEATURES: 10″ Subwoofer Driver; Custom Metal Stamped Basket; Special Poly Injection Cone; Butyl Rubber Surround; 2″ High Temperature KAPTON Voice Coil; 80 oz High Density Barium Ferrite Magnet; Power Handling: 500 Watts RMS / 1000 Watts Peak; Frequency Response: 30-2KHz; Impedance (Per Coil): 4 Ohms; Efficiency: 89 Db; Mounting Depth: 5-1/2″.
Category: 10 subwoofers car audio
Tags: 4 ohms > barium ferrite magnet > butyl rubber > driver > FEATURES > High > high density > peak frequency > Pentagon > Per Coil > PLPNW10 > product > Pyle > Shaped > Subwoofer > voice coil > Watts > watts rms
Tags: 4 ohms > barium ferrite magnet > butyl rubber > driver > FEATURES > High > high density > peak frequency > Pentagon > Per Coil > PLPNW10 > product > Pyle > Shaped > Subwoofer > voice coil > Watts > watts rms
Comments
One Response to “PYLE PLPN-W10 10+ Pentagon Shaped Subwoofer Driver”
Leave a Reply
-
Top 10 Subwoofers Car Audio
Top 10 Subwoofers Car Audio
December 16th, 2009 @ 7:32 pm
I purchased these speakers to replace ones in MCS cabinets that went bad.(the foam edges disintegrated). The original were 10″ Honeycombed flat cone speakers. I had to cut the box out a little because the Pyle speakers were a little larger. I was worried about the port not being large enough, but it was only a little smaller than suggested by Pyle. Overall the sound is terrific. It made a big difference in the sound of those speaker cabinets. I’m really enjoying them now! I would buy these again without question!